Week 15: Reflection


Comments

Post a Comment

Popular posts from this blog

Week 15: tutorial for the metal blister

Image
THE BLISTER TUTORIAL BEIL0014 – DIGITAL MAKING   Before creating the metal blister, it is strongly suggested to watch a tutorial video from the Youtube -  Metalshaping tricks # 5 , which it will help to understand the process and provide a outline for the creating steps:   Steps:  1. Creating the frame 2. Cutting the sheet 3. Shaping the deep 4. Finalising the blister Step 1 - Creating the module The based module made by MDF board should be draw and cut in following the specific outline by course tutors before the class. Two people would be a small group to create a pair of metal blister shape within two weeks, which the metal shape to be creating in the first week, and the second week should be left for adjusting with the group mate.  To creating the round shape in the middle, two tools should be carefully used into this process, which they should make the shape easy to cut and achieve smooth edge for later ...
Read more

Week 4: Finish the bowl and start the torus

Image
Made the bowl better curve with English Wheels. Then I started to create the second metal items - the torus Firstly, cutting the large metal sheet to rectangle shape by the guillotine, which it only can cut metal sheets and flexible plastics. And then, using the metal roller to bend the flat metal sheet become a curve sheet, the process has been done many times to create a perfect curve. After that, I tried to use the metal bender to bend the entire U-sheet become a curve shape as well... The result seems not good😅 Therefore, I started to create the second torus, which using different process to create the same shape to the metal sheet The timber module has been created with a smooth notch. The tools for the second torus are the hammers and a iron shapes with holders.  The metal sheet was cut to become a rectangle sheet and roll to the timber module; then started to beat the middle into the notch, and keep this process until ...
Read more

Week 13: Enhancing the front the grille and module for bonnet grille

Image
The radiator grille, fog lamp and the front bumper still were developing in this week and close to be finalised at current stage. The appearance is built to close the original design of the car as much as possible. However, the curved edge for the bumper is a very difficult part during this process, since I have tried to create the bonnet and the front bumper in one piece, and the front radiator and fog lamp shape also was built firstly, which it would not be easy to do curve process and different angles need to be beat and bend; two tutors demonstrated by themselves for this process to me at the left edge, and I tried to bend the right edge.  Using curve iron shape and hammers has to keep making the sheet fold and bend to form the shape. After a long time to adjust the front bumper, the shape and curve was closed with the edge of the car module. And then, I started to create the module of the three grille on the bonnet, which MDF board would be the first choi...
Read more