Week 1: Non-Class this week


No Class This Week 

Comments

Post a Comment

Popular posts from this blog

Week 15: tutorial for the metal blister

Image
THE BLISTER TUTORIAL BEIL0014 – DIGITAL MAKING   Before creating the metal blister, it is strongly suggested to watch a tutorial video from the Youtube -  Metalshaping tricks # 5 , which it will help to understand the process and provide a outline for the creating steps:   Steps:  1. Creating the frame 2. Cutting the sheet 3. Shaping the deep 4. Finalising the blister Step 1 - Creating the module The based module made by MDF board should be draw and cut in following the specific outline by course tutors before the class. Two people would be a small group to create a pair of metal blister shape within two weeks, which the metal shape to be creating in the first week, and the second week should be left for adjusting with the group mate.  To creating the round shape in the middle, two tools should be carefully used into this process, which they should make the shape easy to cut and achieve smooth edge for later ...
Read more

Week 4: Finish the bowl and start the torus

Image
Made the bowl better curve with English Wheels. Then I started to create the second metal items - the torus Firstly, cutting the large metal sheet to rectangle shape by the guillotine, which it only can cut metal sheets and flexible plastics. And then, using the metal roller to bend the flat metal sheet become a curve sheet, the process has been done many times to create a perfect curve. After that, I tried to use the metal bender to bend the entire U-sheet become a curve shape as well... The result seems not good😅 Therefore, I started to create the second torus, which using different process to create the same shape to the metal sheet The timber module has been created with a smooth notch. The tools for the second torus are the hammers and a iron shapes with holders.  The metal sheet was cut to become a rectangle sheet and roll to the timber module; then started to beat the middle into the notch, and keep this process until ...
Read more

Week 2: Introduction of Digital Making & Metal Shaping

Image
Tutor has shown us the introduction of digital making and metal shaping. Russell showed some of the machines and tools in the workshop. - Bandsaw, drill, disc sander, etc. Also some locations, storage, workshop, and toilet etc. Laser cutting introduction by another tutor, which using Illustrator to create the route of laser cutting.
Read more