Week 9: The Ferrari 250 gto cutting and shaping


Our group mates has divided the Ferrari digital model into pieces by 123dMake before the class. Then we can start to laser cutting the MDF boards for the Ferrari Pieces.



 The illustrator programme print into the laser cutting programme in the lab, then set all the figures up to process the cutting.


In this week, we have cutting all the pieces for the Ferrari module, which X-total 22 pieces, Y-total 18 piece for shaping the car.






After that, it has been started to put into one entire module for the metal pieces shaping.







Comments

Post a Comment

Popular posts from this blog

Week 14: Finish the Ferrarri 250 GTO

Image
After 3 weeks modeling the Ferrari 250 GTO, all the metal pieces have started to place on the original board module. But Firstly, the three holes for the grille on the bonnet need to finish. At the beginning, using the module of three holes I made last week to draw the outline on the metal sheet, which this part should be careful for their location; Then it was started to drill small holes inside of the outline to create the gap for cutting the straight line; Finally, in terms of cutting just a straight line, using the jigsaw with a specific blade for metal sheet to create the line. (CAUTION: since the blade has thickness, we should to measure the location and cut inside of the outline). Eventually, I have finished all the holes and using plastic hammer with some thin timber stick to create the deep of the grilles, which just like the process of the blister.   Cutting out some extra edges for suit the original car module and group mates pieces. We started t
Read more

Week 15: tutorial for the metal blister

Image
THE BLISTER TUTORIAL BEIL0014 – DIGITAL MAKING   Before creating the metal blister, it is strongly suggested to watch a tutorial video from the Youtube -  Metalshaping tricks # 5 , which it will help to understand the process and provide a outline for the creating steps:   Steps:  1. Creating the frame 2. Cutting the sheet 3. Shaping the deep 4. Finalising the blister Step 1 - Creating the module The based module made by MDF board should be draw and cut in following the specific outline by course tutors before the class. Two people would be a small group to create a pair of metal blister shape within two weeks, which the metal shape to be creating in the first week, and the second week should be left for adjusting with the group mate.  To creating the round shape in the middle, two tools should be carefully used into this process, which they should make the shape easy to cut and achieve smooth edge for later process - jigsaw, sander and.
Read more